1) Different properties
1. Rockwell hardness is an index that determines the hardness value based on the depth of plastic deformation of indentation. 0.002 mm is used as a hardness unit.
2. Vickers hardness refers to using a diamond right pyramid indenter with an angle between opposite surfaces of 136 degrees, pressing into the surface of the test sample under the action of the specified load F, holding it for a certain time, then removing the load, and measuring the indentation. The diagonal length d is then used to calculate the indentation surface area, and finally the average pressure on the indentation surface area is found, which is the Vickers hardness value of the metal, represented by the symbol HV.
2) Measuring different hardnesses
1. Rockwell hardness (HR) measures hardness by indentation depth.
2. Vickers hardness (HV) is pressed into the surface of the material with a load within 120kg and a diamond square cone indenter with a vertex angle of 136°. The load value is divided by the surface area of the material indentation pit, which is the Vickers hardness value. (HV).
3) Different scope of application
1. The Rockwell hardness indentation is very small, and the measured value is localized. Several points must be measured to find the average. It is suitable for finished products and thin slices, and falls into the category of non-destructive testing.
2. Vickers hardness is suitable for hardness measurement of larger workpieces and deeper surface layers. Vickers hardness also includes small-load Vickers hardness, which is suitable for the hardness determination of thin workpieces, tool surfaces or coatings; micro-Vickers hardness, test load <1.961N, is suitable for the hardness determination of metal foils and extremely thin surface layers .
